Does anyone need any clips, trim, connectors etc

S

synthedup

Senior member
 Rotherham
Hi all,

I’m at the stage now where I will be scrapping the car shortly.

I still have loads of clips, plastic trim, connectors etc.

Does anyone need anything?
 
I could do with the front bumper clips and any door card clips if u have them?
The airbag module arrived ok btw. Thx :thumbsup:
Wish ida thought of clips before. *headslap*
 
I'm assuming the front bumper reflectors are gone? Out of curiosity, how does the car look like now?
 
Have you any rear shelf clips or circular trim covers from the centre console or rear quarter panels ?
 
I will take any centre console screws n covers please. Also under bonnet screws etc on front plastic cover around bonnet catch.
Let me know about ££
Cheers
 
There's a small rubber insert in the inside of the bonnet in the highlighted area that I need. Mine fell while I was cleaning the engine bay and now there's a bit of a rattle from that side of the bonnet. I can't remember exactly where it is, but I think it is close to the near side latch.

If you still have it, just send me a PM with paypal details, etc.

zPGCwyx.jpg
 
Do you have the rubber trims that sit under the roll hoops?

Also, the rear bumper mounting bracket? (The long thin 1 that goes between the brake lights under the boot)

Thanks
 
Do you have the storage nets for the passenger footwell or the offside rear of the boot, please?
 
I'd be interested in the centre console lid...I broke the catch on mine so the damn thing won't stay shut :(
I'm also after a black leather passenger sun visor as the mirror is broken on mine. Happy to drive down and collect.
 
TheThingIs said:
I'd be interested in the centre console lid...I broke the catch on mine so the damn thing won't stay shut :(
I'm also after a black leather passenger sun visor as the mirror is broken on mine. Happy to drive down and collect.
Click to expand...

Leather sun visor will be like hens teeth. You’ll probably have to get a standard one and swap the mirror over.
 
Hey do you have the oil sump hatch cover available, mine lost its screw so doesnt stay closed.
Number 4 from the pic below
Capture.JPG
 
If they've not gone already I need two screw covers, one for behind door release lever, drivers side.
The second for the centre tunnel side wall, again drivers side, near the front of the seat. Parallel with the hazard warning switch.
Let me know posted cost.
 
Hey OP, bit of a long shot but do you still have the micro switch that goes in the boot? Mine seems to have disappeared. Will take the whole plastic housing that screws into the boot wall if you’ve still got it.
 
You must log in or register to reply here.
Back
Top Bottom