I've never cleaned and engine bay before, so one big question is before I hose or pressure wash the engine bay to get rid of most of the dirt is there anything I should protect or be careful of before hand? It's an E85 btw.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Detailing engine bay
- Thread starter MartynFrancis
- Start date
Alternator and any wires should be wrapped up in plastic bags.
I don't pressure wash or hose, another method is using a degreaser or all purpose cleaner with brushes to agitate the dirt then wipe with cloths. Or steam clean but again be mindful of the electrical components.
I don't pressure wash or hose, another method is using a degreaser or all purpose cleaner with brushes to agitate the dirt then wipe with cloths. Or steam clean but again be mindful of the electrical components.
Nice one, cheers mate!
Nothing wrong with pressure washing or using a hose with an attachment.
As above any major electrics, wires, battery, alternator to be wrapped. I normally use cling film. Please do not use kitchen foil, as stupid this may seem I have known a hand full of people to try it and others recommending it. Almost all modern vehicle engines wont be affected if any components get wet, as of most don't have an under tray neither, but its always safe than sorry.
When rinsing be sure not to flood any components, rinse only using a fine mist. If using a pressure washer, stand far back not to apply to much pressure towards any delicate parts. If in any doubts clean using a damp cloth instead.
As above any major electrics, wires, battery, alternator to be wrapped. I normally use cling film. Please do not use kitchen foil, as stupid this may seem I have known a hand full of people to try it and others recommending it. Almost all modern vehicle engines wont be affected if any components get wet, as of most don't have an under tray neither, but its always safe than sorry.
When rinsing be sure not to flood any components, rinse only using a fine mist. If using a pressure washer, stand far back not to apply to much pressure towards any delicate parts. If in any doubts clean using a damp cloth instead.