CSL’

You can achieve a "staggered" set up with 4 of the same width wheels .
Different offset or tyre size ( or both ) can also produce a staggered wheelset
 
drummachine said:
Thanks guys - simples :)

Can you advise the correct fitment to go straight onto a Z4M just so i'm 100% sure?

Thanks all

Chris

The 'standard' wheels are style 224's
 

Attachments

  • Screenshot-2018-11-12-at-13.18.57.gif
    Screenshot-2018-11-12-at-13.18.57.gif
    12 KB · Views: 2,782
drummachine said:
Does anyone have any idea/experience on what et 27 front and et 35 rear would look like or fit like?

You néed to throw in the rim widths with the offsets for clarity but et27 on front of a ZM is low.
The et35 rear not a problem if 9, 9.5 or 10j.
You could even get a spacer behind depending on rim width
 
drummachine said:
Does anyone have any idea/experience on what et 27 front and et 35 rear would look like or fit like?


I have 9” x 19” with et 31 on the front, looks ok, rubs the arch liner a little on full left lock in reverse, other than that no problem.
 
drummachine said:
The one's i have spotted are 9.5j all round with 265 tyres

Spacers may be an option?

Thread objective is all over the place :cry:
Are you asking if a 9.5j et 27 will fit front Z4M & 9.5j et 35 will fit rear? All with 265 tyres?
If so you will be fine once front arch liners are removed , otherwise forget it
 
Hi guys

Just fitting some CSL wheels as we speak (genuine) and I was told the center caps would swap from my OEM wheels but they seem quite loose?
 
Are the centre caps OEM ?

I bought some on eBay and they were loose, I wrapped around the prongs a few times with tape.
 
Some of the ones on eBay are crap. I bought some and wasn’t impressed at all. In the end I purchased OEM and they were in a different class.
 
Back
Top Bottom