Cruise Control question

ZedVier

ZedVier

Member
 Stillwater Minnesota
I have a friend who’s particularly disabled and he’s thinking that it would be significantly easier to drive his 2006 Z4M if it had cruise control. It looks like some of the folks on this forum have had experience doing a retro upgrade (rshutch?). Anyway if someone could point me in the right direction on how and where to get the best retro loom, I would appreciate it very greatly. Thanks
 
You're already on the right track as I believe @srhutch still makes up the section of wiring loom required, and now you've made 5 posts you can send him a DM.
 
0

Thread 'Fuse Box Wiring or Connector 11007 Pinout Z4M'

I've managed to get hold of a loom de pinned from a factory fitment cruise. This way I don't have to splice into the LCM wires and everything in installed as per the factory.

The wire to the ECU and ground are easy and sorted.

However, the wire to the fuse box is causing me some confusion. According to the wiring diagram, it should go to pin 7 of connector X11007 on the back of the fuse box and be powered by fuse 21.

However, this location is already taken on that connector block. I've searched through the wiring diagrams and come out with a pinout for X11007 but there are a number of...
  • Like

Recently did this the non intrusive way, not a single wire spliced. Info is in the thread above.

Really easy.
 
You must log in or register to reply here.
Back
Top Bottom