Code PO344 - crankshaft position sensor

[davegt]

As part of the "getting to know your new car" process I plugged it in to my diagnostic software, there are no error lights on the dash and the engine is running without fault but it flashed up Code PO344 with is the crankshaft position sensor (A) I've googled and check realoem without much luck, does any know the part number and have a "how to" for diy replacement.

I cleared the code and it hasn't come back but I'd rather just change it out anyway for piece of mind

 

[srhutch]

It may have been replaced but they did not clear the code.

 

[davegt]

It may have been replaced but they did not clear the code.

Didn't think of that, once I find where it is on the N52 I'll check the condition, I'll check for codes again after the weekend and see if they come back up as well