CAD template for wheel fitment

[ba3bas]

Hi, it's been a while since I've used cad so hoping someone here can help

What I'd like is a template of the rear axle in cad form.

This would be used to see if certain wheels will fit under the arches.

As I can see based on my own experience, you could get et32 9.5j on the back without issues and maybe some arch rolling.

But what about 10.5j?

Clearance on non/m is the arch as opposed to the inner lining.

 

[ben g]

I have 10j et 38 rears on

10.5j with a higher offset may be possible.

 

[ba3bas]

How big is the lip on your LMR?

Any pics?

 

[ben g]

Here's one I took literally 5 minutes ago, showing off to a mate on WhatsApp :lol:

 

[GP06Roadster]

http://www.willtheyfit.com/index.php?width=235&aspect=40&diameter=18&wheelwidth=8.0&offset=32&width2=235&aspect2=40&diameter2=18&wheelwidth2=8.5&offset2=38#content

I think you would need an offset of at least 45-50 for a 10.5 rim. Try the calculator above to compare your current rims. I suspect even then strut clearance could by too little?

 

[ba3bas]

10.5J won't work on the stock axle unless I stiffen the rear springs and a guaranteed rebound stop so not to foul the arch.
Not with the lip I want too.

Just currently figuring out which summer wheels I want now.

Let's just say rare and retro.

Max sizes 10J ET35 on my car for the Rear.
With a decent lip 9.5J ET32

Will fit perfectly