Bulb warning

S

Sgr74

Active member
 Sunny Fife, Scotland
If you have a bulb warning light on then you fix the bulb, do you need to reset it or will it reset automatically?
 
Sgr74 said:
If you have a bulb warning light on then you fix the bulb, do you need to reset it or will it reset automatically?
Click to expand...

Should be automatic, unless it’s a wiring fault in which case the light will stay on :thumbsup:
Rob
 
It’s strange, I fitted 2xcite lights. First I connected the wires with just spade connectors to see if I was doing it correctly. They worked fine with no Warning light. I then took them back off and soldered them with a heat shrink sleeve over the joins, now I have a warning light. Will a Code reader pin point the problem or just tell me I have a problem?
 
Sgr74 said:
It’s strange, I fitted 2xcite lights. First I connected the wires with just spade connectors to see if I was doing it correctly. They worked fine with no Warning light. I then took them back off and soldered them with a heat shrink sleeve over the joins, now I have a warning light. Will a Code reader pin point the problem or just tell me I have a problem?
Click to expand...

It sounds like you’ve answered your own question, it’s got to be one side or the other (or maybe both) where you’ve made new connections :?
Rob
 
Dismantled and re-soldered the wires earlier. Still the same. I’ll have to get my mate to bring his code reader home from work and get him to check it.
 
You must log in or register to reply here.
Back
Top Bottom