Breaking the Zed Everything for sale!

[enuff_zed]

Are they with the screws and plugs? If so, that would be great.

The plastic captive nuts (plugs) didn't survive removal. They are very much single use once pushed into place.

Ah, that is a bit of a problem as they are £10 for a set

Oh my! You may have to sell one of the fleet.

 

[hollie040]

Sorry to hear about your car, hope you're physically ok after that. Not wanting to pick over the bones of the dead, but if the steering wheel is leather, is it still available? My car only has the povvo plastic one. I'm over in Queens Hills (Longwater), so not too far.

 

[pvr]

The plastic captive nuts (plugs) didn't survive removal. They are very much single use once pushed into place.

Ah, that is a bit of a problem as they are £10 for a set

Oh my! You may have to sell one of the fleet.

I just have to cut down on the heating when you are next here
Let’s have the brackets and screws then, I will check for a better location for the plugs. I see on eBay that the non BMW ones are more reasonable

 

[john-e89]

Interested in the rear bumper with cut out and dual side pipes if the other interested member doesn’t proceed Jock.

 

[Neens76]

What a crying shame. I’ll be very interested in the CSL reps, should they still be available? And if Martin don’t mind waiting till I can top up the coffers for the rear suspension refresh job in a couple months - after doing my front recently :wink:

 

[RMB]

[ref]jock156[/ref], Do you have the trim cowl piece under the steering wheel? The part the cruise stalk goes into? With or without cut out.
Edit I see someone has already asked. 2nd dibs please.

Also if you were running 3.0si brakes, do you have the correct splash guards available? 34116759787/8 ? Thanks

 

[BMWZ4MC]

Hope you’ve fully recovered now? This is a sad end to a very nicely modified car.
I’ve only just seen this thread but as posted in your “Ah well” thread, I’m very interested in the cill extensions attached to the aeroskirts (but not the aeroskirts themselves).
Also, if there are cupholders and the driver’s side is in good condition, I’d be interested in that too.
We’ll be back in the UK for a few weeks fairly soon and I’ll be gathering parts for my Lotus whilst we’re there, so would be keen to ship everything to Aus in one box

 

[Ilogik]

how much for the side skirt splitters? also drivers side sill cover if its just a standard BMW one. Might also be after some interior plastics.

 

[jock156]

Interested in the rear bumper with cut out and dual side pipes if the other interested member doesn’t proceed Jock.

Hi John, rear bumper incl. parking sensors, £100 takes it away

Do you mean you only want the quad exhaust part that is visible? I’d rather sell the whole exhaust :wink:

 

[john-e89]

Interested in the rear bumper with cut out and dual side pipes if the other interested member doesn’t proceed Jock.

Hi John, rear bumper incl. parking sensors, £100 takes it away

Do you mean you only want the quad exhaust part that is visible? I’d rather sell the whole exhaust :wink:

Sorry Jock I must’ve had my brain switched off…I don’t really need the bumper tbh, but depending on drone levels I’m keen on the whole exhaust.

 

[jock156]

Martin will attest to the age group of my neighbours (and sausage rolls) so I made sure when it was fabricated that it wasn’t noisy or droney - is that even a word???

It’s just a bit more sporty than a standard exhaust

I would like it gone ASAP as it’s the only thing that’s stopping the car being scrapped :wink:

 

[Paul345]

Interested in the rear bumper with cut out and dual side pipes if the other interested member doesn’t proceed Jock.

Hi John, rear bumper incl. parking sensors, £100 takes it away

Do you mean you only want the quad exhaust part that is visible? I’d rather sell the whole exhaust :wink:

Sorry Jock I must’ve had my brain switched off…I don’t really need the bumper tbh, but depending on drone levels I’m keen on the whole exhaust.

I'll pass on the exhaust, so if you want go ahead.

 

[john-e89]

Martin will attest to the age group of my neighbours (and sausage rolls) so I made sure when it was fabricated that it wasn’t noisy or droney - is that even a word???

It’s just a bit more sporty than a standard exhaust

I would like it gone ASAP as it’s the only thing that’s stopping the car being scrapped :wink:

Hit me Jock… ….?? :lol:

 

[jock156]

£200 if it’s gone by Sunday! You will need to bring a jack and all necessary tools as I don’t have much in the way of tools

 

[Hb1]

Do you have an interior photo?
I could do with some good condition aluminium door handle trims, the plastic under the hand brake and a drivers side cup holder.

Thanks

Bump :wink:

 

[jock156]

Hb1 I can help with the cup holder

 

[Hb1]

Sure thing, how much?

 

[Neens76]

What a crying shame. I’ll be very interested in the CSL reps, should they still be available? And if Martin don’t mind waiting till I can top up the coffers for the rear suspension refresh job in a couple months - after doing my front recently :wink:

You might have missed this with so many replies, so bumping up. Thanks in advance Jock156

 

[john-e89]

£200 if it’s gone by Sunday! You will need to bring a jack and all necessary tools as I don’t have much in the way of tools

Ah ok, I thought it off and could be couriered perhaps, I’ll have to pass then, sorry Jock, I’ve got a mini digger on hire and up to my eyes at the moment. Shame really.

 

[jock156]

No worries John!