bonnet catch adjustment?

B

Buckz

Senior member
 West sussex
Anyone know the actual location? My bonnet seems to be lifted in the center but fine on the sides..

There's probably 10-15 travel if I push it down
 
Can't see the images from my PC. :? I have only ever tweaked the adjustment at each side. Not even sure there is one in the centre..
 
Not sure you can adjust the centre latch, but someone on here might know differently. However it could be the bumper out of alignment. When you remove the bumper, if you put it back on and don't push it in as you do up the torx screws you can be left with a panel gap, which may then look like the bumper is not closing properly. If you loosen the screws and then push the bumper forward and tighten them up it may fix the issue.
 
I wonder, I looked around and I can't see any adjustment in the center. It's not terrible but there's some travel which I do not expect to be there.. maybe I'm overreacting.
 
You can see the gap in the center, not sure if that's normal.
 

Attachments

  • 20170705_233407.jpg
    20170705_233407.jpg
    197.8 KB · Views: 2,057
iPhone only so can't judge images
If the bonnet is too high you adjust by screwing the loop on the bonnet in after releasing the plastic locking cover.
Corners can be stabilised by screwing the rubber stops in or out. Later models have spring loaded adjusters
If a panel gap then as above adjust the bumper cover torx
 
You must log in or register to reply here.
Back
Top Bottom