BMW Z4 airbag modules programming error

J

Jmz4

New member
Hello friends, I have a problem with my car not recognizing my airbag modules SBSR, SBSL, SVTR, SVTL. After I tried to code them to the car with PROGMAN SSS. I also tried to use tool32 and it is not recognizing them as being installed in my car. I also tried winkpf and NCS and still the same. I would like to know if there is any way of returning them to there original condition so the I can code them to my car.
 
Hi Jmz4 and welcome to the forum. Plenty of advise on here and at least you car problem led you find us. To paraphrase an old yellow pages advert 'were not just here for the bad things' so how about a picture of your Zed and an introduction?
 
Why did you code then to the car? Normally if you cannot see any of the modules then it's the main airbag module which has failed, speak to KIS on here as he had a similar problem
 
You must log in or register to reply here.
Back
Top Bottom