So I went to BMW today and ordered the parts for the missing headlight nozzle and washer nozzle cover.
Also two tiny blanking pieces for the interior that were missing. £66 all in.
To paint it they want £40 or £25 for a rattlecan.
So as suggested before I'm going to try and blag it down a BMW repair centre, and if not I'll have to resort to using a rattle can and laquer. Not done that before on anything other than engine bay bolts etc, but how hard can it be. :?
The parts guys said that to fit the top of the nozzle to the bottom you need to take the bumper off?
Has anyone done this already and can explain if this is the case?
It looks like this at the moment:
I'm going to use this how to http://www.z4-forum.com/forum/viewtopic.php?f=28&t=1071&hilit=bumper+remove
and then hope the nozzle bits looks self explanatory. :wink:
Also two tiny blanking pieces for the interior that were missing. £66 all in.
To paint it they want £40 or £25 for a rattlecan.
So as suggested before I'm going to try and blag it down a BMW repair centre, and if not I'll have to resort to using a rattle can and laquer. Not done that before on anything other than engine bay bolts etc, but how hard can it be. :?
The parts guys said that to fit the top of the nozzle to the bottom you need to take the bumper off?
Has anyone done this already and can explain if this is the case?
It looks like this at the moment:
I'm going to use this how to http://www.z4-forum.com/forum/viewtopic.php?f=28&t=1071&hilit=bumper+remove
and then hope the nozzle bits looks self explanatory. :wink:
