A guide for skinning the leather off (MSport) leather seats

P

ProfCJJ

Member
A few weeks ago I purchased a pair of electric, memory, heated MSport seats from a breaker which were in top condition. I used them as donors to place the leather off my MSport manual non-heated seats in Koral red leather onto the frame. Essentially, I skinned the leather off the black "donor" seats, then did the same with my Koral red seats and swapped the leather around. As I essentially did this process 4 times now I decided to document the process, so I created a PDF of a "how-to" that I link below (can we not upload PDFs to the forum?)

I did this for the driver's seat but of course the process is the same for either seat.

I hope this might be useful for someone who is trying to do this.

:thumbsup:

Dropbox

www.dropbox.com www.dropbox.com
 
The only problem with those staple type hog rings, you can end up with pointy bits sticking through leather. Better if you can find round.
 
flybobbie said:
The only problem with those staple type hog rings, you can end up with pointy bits sticking through leather. Better if you can find round.
Click to expand...

The ones I have (and I have since bought more variety) close really tightly and whilst not really round they end up like squares with very rounded edges. Plus I make sure the “pointy” ends are pointing into the foam when applied. Time will tell :!:
 
You must log in or register to reply here.
Back
Top Bottom