326M manufacture

[Pondy]

As I'm paranoid about the 326s cracking, when I hit a couple of quite big potholes at the weekend (couldn't see them until too late), I had all four wheels off yesterday to check for damage. They were all fine (so far), but I noticed that mine are stamped as being manufactured in Poland by Ronal.
Does anyone know if all 326s were made by them?

 

[enuff_zed]

Well you're in luck then my friend.
Pot holes are no problem for these Hot Poles.

 

[Pondy]

Well you're in luck then my friend.
Pot holes are no problem for these Hot Poles.

:roll:

 

[warmasice]

Mine are by Ronal and I'm pretty certain they all are.

 

[SV8Predator]

Are you put off by the fact that they're manufactured in Poland?

 

[jamie_z4]

not sure if its the same with 326M's but with 313s fitted to the E9* range, they did 'early' ones which cracked to buggery, but then a revised version appeared circa 2011 which had a thicker inner lip which seem more robust.

 

[Pondy]

Are you put off by the fact that they're manufactured in Poland?

No; why would I be?
I was trying to find out if all the 326s were made in the same place, which may account for some being stronger than others if they were not!

 

[kinger]

Here are the markings on my recently broken 326 rear
From my 2010 car
Also a pic of my shiney new wheel.
It was sold to me as a refurb but i think its brand new
Funnily enough, i bought it from Poland!!

 

[Amg01]

Here are the markings on my recently broken 326 rear
From my 2010 car
Also a pic of my shiney new wheel.
It was sold to me as a refurb but i think its brand new
Funnily enough, i bought it from Poland!!

Where did you get the new wheel and how much was it?