3.0SE standard exhaust £80

SqerrNipz

Member
 Oxford
Standard exhaust system from my 2004 3.0SE. I’ve put a gravity performance system on and was keeping this in the event it wasn’t to my liking or if I ever sold the car. Realistically I won’t swap back and it’s just taking up space in my garage.

Good condition, was leak-tested before removal and none found. Looking for £80 and collection only as it’s very heavy. I managed to fit it in my X1 with boot partially open.

Cheers,
Tony

20230710-141623.jpg

20230710-141603.jpg

20230710-141610.jpg
 
enuff_zed said:
Surely you could get a decent amount just for the cats?

Seems a shame, it’s in good condition. I thought somebody would have it to replace a rusty/holey one.

There’s a few car parks near me where I could leave it and it would be gone in 30 seconds… even attached to the car! :lol:
 
SqerrNipz said:
Bump, price reduced to £80!
I don't suppose you still have this do you? Sorry if this is a stupid question, but is it all sections including the manifold end? If it's the whole lot and you've still got it, I definitely want this off you asap!
 
Rossi1001 said:
SqerrNipz said:
Bump, price reduced to £80!
I don't suppose you still have this do you? Sorry if this is a stupid question, but is it all sections including the manifold end? If it's the whole lot and you've still got it, I definitely want this off you asap!

Sorry for the delay, I've not been on the forum for a while - life getting in the way! I still have the exhaust, it's the full system from the manifold back, in photos above. Feel free to PM me and I will make sure I get on here a bit more to check messages :thumbsup:
 
SqerrNipz said:
Rossi1001 said:
SqerrNipz said:
Bump, price reduced to £80!
I don't suppose you still have this do you? Sorry if this is a stupid question, but is it all sections including the manifold end? If it's the whole lot and you've still got it, I definitely want this off you asap!

Sorry for the delay, I've not been on the forum for a while - life getting in the way! I still have the exhaust, it's the full system from the manifold back, in photos above. Feel free to PM me and I will make sure I get on here a bit more to check messages :thumbsup:

Oooh that is good news!

It's only the manifold section on mine that's cracked (both pipes too grrr!) though what I can do is take the whole thing and use whatever is best on the rear and mid sections. I'll PM you!

EDIT From my poking around on RealOEM, I think the 3.0 and 2.5 both shared the exact same exhaust part numbers (certainly at the manifold / engine end) as mine is a 2.5. I'm right on this I think?!
 
Back
Top Bottom