Prise the jacking points out with a screwdriver. To refit, push the centre bung out, fit them to the car then push the bung back in to hold them in place.EnzoBlack wrote: Mon Jun 16, 2025 8:20 pm Ok, I'll keep an eye on the AC and the dampness on the passenger footwell carpet.
I'll take the rubber jacking points off and drive up and down a couple of hills to get the water fully out. Is there a method to taking them off or do you just jimmy them off with a screwdriver?
Do you know how to take the windscreen plastic cowling off? I have to see if there is any blockage to that drain.
Thanks very much for your help!
Remove the wiper arms then pop out the plastic rivets along the lower edge of the scuttle panel. Carefully slide a trim tool between the windscreen and the top edge of the panel and lift it to unseat the push clips. Some may well break, but it's easy to find replacements on eBay.
