Is it ok to wrap the hydraulic pump and foam completely in plastic sheeting! Rather than just around the base and sides of the foam? Or would you get condensation forming inside?
We don't have the Z4 any more but we found that in manufacture there is a boot seal which appeared to have poor quality sealant which had gone hard and crumbled rendering the seal itself ineffective. We replaced the sealant with a good quality sealant (we didn't replace the seal itself as it seemed good and also it was nearly €200 to replace. Hope this is a bit helpful.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
