How to - E85 Z4 rear shock absorber fitting

User avatar
Posts: 850
Joined: Mon Jul 16, 2012 5:33 pm

How to - E85 Z4 rear shock absorber fitting

Post by dhobbs » Fri Aug 25, 2017 4:43 pm

Just used this guide and thought it was really useful. :thumbsup:

My only point to add, is to disconnect the xenon leveller switch on the offside swing-arm if you are replacing the springs at the same time. I had to push down on the hub to get the old spring out, and there is potential to damage the switch if it's still connected. Note, it's only if you have factory xenons!
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. Dension. ZHP gearknob. Daily drive :driving:
Motor in boot now! Bilstein b12 kit now fitted.

Post Reply