Z4m Rear Bumper Support

J

Jamie-innes

Member
 Scotland
Hi all, just wondering if anyone has experience with switching from a facelift rear bumper to the Z4m bumper and had to make up a support between the mid section and the two unused screws from the old bumper?
I have a few questions as I bought some 1mm abs but it seems too thin to use.

1. Is support really needed for this section?
2. Am i just as well cutting up the old bumper rather than selling and using the money to buy a large enough sheet of abs?
3. Will adding in a support affect the routing of the quad exhuast past this section?

Any advice or opinions are appreciated, I'm more on the side of securing it for peace of mind, tempted to take a sheet of black abs offcut from work now after spending money on a useless sheet already :rofl:
 
I cut up an old bumper. This will "tie into" your car. You can then bolt up the M bumper to the standard bumper.
I'm sure there are other ways you can achieve this. But that's what I did :)

38164671-817F-4EC6-B328-A92FF12DBE3A.jpeg
 
kis said:
Don't ask :? It's the correct way round on my computer!
Click to expand...
Haha it's exactly what i was looking for though, looks like the old bumper will be getting it :thumbsup: don't think they sell for much anyway
 
You must log in or register to reply here.
Back
Top Bottom