Z4 E85 E86 roll Hoops Black from Z4MR

Wassup

Active member
Will be available at end of the month when my Z4MR will be Sorned. Will come with wind deflector brackets only and not the wind deflector shown below as it's offered for sale in a separate thread.

Rare opportunity to purchase a set of roll Hoops off the Z4MR, these are the black variant only found on the Z4MR.

Never seen these offered for sale before and will not know how cleenly they come off the car as some of the mounting tabs will undoubtedly break upon removal. Assuming they come off in a reusable manner, I'll offer them for £200 or nearest offer.

Prefer collection from Sutton Coldfield near Lichfield or happy to post at buyers expense.
IMG_20220616_213029.jpg
 
Regrettably car is being parted out, its had far too many mechanical and electrical gremlins which I've tried to resolve over the past 18 months but given the rarity of good used Z4M specific parts, it's proved an expensive and futile effort :thumbsdown:

Most frustrating gremlin had to be the ZF gearbox, initially installing a brand new LUK clutch kit and flywheel (original flywheel and clutch was severly worn) only to then discover the 'synchro mesh' and/or selector rods may have been damaged previously. Even got desperate and tried fitting an E46 M3 manual gearbox to no avail (marginally longer meaning non centered Shifter, shorter propshaft etc).

Then, there's the knackered differential which requires a full rebuild and a very noisy propshaft (something to do with worn internals whatever that means!).

And more recently, problems with DME/EWS/no Crank no start... Truth be told it was a high mileage car (102k) when I bought it and clearly had a hard/abused life. Granted I bought it cheap due to its problems (forgot to mention patchy/shoddy paintwork) but to put it right now would be uneconomical and I just don't have any more patience nor funds to sink into it.

I guess the old adage "you get what you pay for" really resonates in this instance...
 
More detailed pictures added
 

Attachments

  • IMG_20220624_124454.jpg
    IMG_20220624_124454.jpg
    145.5 KB · Views: 757
  • IMG_20220624_124503.jpg
    IMG_20220624_124503.jpg
    162.7 KB · Views: 757
  • IMG_20220624_124505.jpg
    IMG_20220624_124505.jpg
    124.3 KB · Views: 757
  • IMG_20220624_124509.jpg
    IMG_20220624_124509.jpg
    158.5 KB · Views: 757
  • IMG_20220624_124513.jpg
    IMG_20220624_124513.jpg
    135.5 KB · Views: 757
  • IMG_20220624_124533.jpg
    IMG_20220624_124533.jpg
    101.7 KB · Views: 757
  • IMG_20220624_124521.jpg
    IMG_20220624_124521.jpg
    143.8 KB · Views: 757
  • IMG_20220624_125152.jpg
    IMG_20220624_125152.jpg
    138.9 KB · Views: 757
Hi, took best part of two hours to remove in the baking sunshine a few week back to give me a better chance of minimal clip breakage. It paid off as only a handful of clips were broken. I've tried to show damaged clips in pics and fortunately where they have broken, there's an opposing one in tact.

There's a scratch on the back of one cover and a rub mark on the front of another, didn't even notice either until removal.
 
Back
Top Bottom