[email protected]
New member
Hi,
I purchased used memory seats to replace my "sport" manual seats. After removing the original seats, I installed the seatbelt sensor into the yellow connector and plugged the connector. The lumbar support is activated, but the forward-backward, tights, and tilt are not working. Where do I start to troubleshoot?
1) How to establish that the used seat I purchased is working? Is there a wire diagram available to allow me plugging 12v to test the seat outside the car?
2) Any issues with the "sport" harness? I read in another post that the harness should be a plug and play.
This is a good start for the post. I returned the manual original seats, so I can drive the car, but I would love to enable memory seats replacement.
Thank you,
I purchased used memory seats to replace my "sport" manual seats. After removing the original seats, I installed the seatbelt sensor into the yellow connector and plugged the connector. The lumbar support is activated, but the forward-backward, tights, and tilt are not working. Where do I start to troubleshoot?
1) How to establish that the used seat I purchased is working? Is there a wire diagram available to allow me plugging 12v to test the seat outside the car?
2) Any issues with the "sport" harness? I read in another post that the harness should be a plug and play.
This is a good start for the post. I returned the manual original seats, so I can drive the car, but I would love to enable memory seats replacement.
Thank you,