Wheel speed sensor

[BeardedAL]

I know this has been talked about in other threads, I just wanted some advice on the below error, obviously ive had the warning lights on the dash and scanned to find the error. Will i need a new one or can it be just dirt etc causing the problem, im new to all this so im not sure the proper course of action other than going to the garage which id rather not do as id like to learn to do these things myself. Thanks in advance

 

[bigwinn]

Probably the easiest of the sensors to change assuming it’s not mega rusty underneath

I tend to find when they fail, they fail. No point in cleaning etc. and when one goes another usually follows soon!

You aren’t far from me so if you want a hand shout up… happy to help

 

[BeardedAL]

Probably the easiest of the sensors to change assuming it’s not mega rusty underneath

I tend to find when they fail, they fail. No point in cleaning etc. and when one goes another usually follows soon!

You aren’t far from me so if you want a hand shout up… happy to help

Thanks mate, appreciate that, I'll get one ordered ( are there particular brands for the sensor that is should buy ) and see how it goes, may take you up on your help. Many thanks

 

[bigwinn]

Bosch are ‘good’ just don’t buy cheap!

No worries

 

[pvr]

Nice message, my Carly just had the code which I had to look up.

I bught a new front left and right rear, but only used the front left in the end. The impact driver managed to get the rust formerly known as bolt out without issues

 

[BeardedAL]

Nice message, my Carly just had the code which I had to look up.

I bught a new front left and right rear, but only used the front left in the end. The impact driver managed to get the rust formerly known as bolt out without issues

I've watched a few YouTube videos of people removing the bolt, i shall see what it looks like once ive removed the wheel and jacked it up. It looks quite straightforward to replace so hopefully i won't have any issues.

 

[pvr]

 

[pvr]

That was the job at the time. Impact driver was really required with the tool bits to grip it