Removing wing mirror cover
- Thread starter Nuts
- Start date
Dave 2 dogs
Senior member
Hey Nuts
If you have a set of plastic prise tools to use , I just went around the edges with the one that looks like a butter knife. It pops off fairly easily. If you use something metal, it would probably damage the edges
If you have a set of plastic prise tools to use , I just went around the edges with the one that looks like a butter knife. It pops off fairly easily. If you use something metal, it would probably damage the edges
Follow this guide, however you don't need to unbolt it from the car, so skip that step:
https://www.pelicanparts.com/techar...ement/57-BODY-Exterior_Mirror_Replacement.htm
https://www.pelicanparts.com/techar...ement/57-BODY-Exterior_Mirror_Replacement.htm
pvr said:
Well done for questioning that. Pelican parts has been my go to over the years and assumed they would be correct. However I must admit I posted the guide without reading it and they are wrong.
The yellow arrow points to the groove you slide a screw driver into and then rotate. This releases the mirror. Do not prise anything until the clip has been rotated:
Nuts said:
Getting the glass out is the difficult part. Angle the glass all the way down. I use a torx 6 single piece screw driver, or a very small cross head is the next best, to slide into the groove and rotate. It can take quite a bit of force.
Now try and hook out the glass. If you're lucky no sticky pads have been used between glass/heatpad and the motor actuator. There's a 50% chance of this. If they have been used then you have to slowly prise it out. It's difficult on your first go.
After you have the glass out the rest is quite easy except for the final two plastic tabs holding the cap on. Jam something into one tabs holding it open, thin piece of solid plastic, and lever the other tab with a flathead screwdriver. Then lightly twist the cap and it should pop off.