New side skirts/steps

R

r1andy

Active member
 northern ireland
These are based on the 3D design side skirts but are wrapped in 3M carbon, if i decide to keep them i will get them wrapped in real carbon fibre to give a perfect finish
DSC_5309copy.jpg
DSC_5305copy.jpg
DSC_5302copy.jpg

3D Design skirt below
6917465574_622d3fae53_c.jpg

The 3D skirt has more of a step but i kept mine in and less of an overhang , prefere it a bit neater.

Cheers.
 
Thanks folks, i will be getting the rear difusser wrapped in real carbon fibre and a 3D front splitter so these will tie the front and the rear of the car just nice (i hope) :)
 
r1andy said:
Thanks folks, i will be getting the rear difusser wrapped in real carbon fibre and a 3D front splitter so these will tie the front and the rear of the car just nice (i hope) :)
Click to expand...

Can I withhold my view till you do this ? Can't make up my mind right now... :D
 
not a problem mr Bing, i am with you on this one, will have to see it all finished before decide to keep them on, but i realy like the 3D design E89 Z4 :)
 
rayz4 said:
Looks real good, where did you get them from :thumbsup:
Click to expand...

Cheers

i made them. they cost me £13 all in
thats a bit cheaper from £1500 odd for the 3D skirts lol.
 
r1andy said:
not a problem mr Bing, i am with you on this one, will have to see it all finished before decide to keep them on, but i realy like the 3D design E89 Z4 :)
Click to expand...

Me too :wub:
 
r1andy said:
rayz4 said:
Looks real good, where did you get them from :thumbsup:
Click to expand...

Cheers

i made them. they cost me £13 all in
thats a bit cheaper from £1500 odd for the 3D skirts lol.
Click to expand...

Good job, look really good what did u make them with


Sent from my iPhone using Tapatalk
 
pvc trim 90mm x 6mm , comes in 5m lengths, you can get this from any pvc window company
cost around £5 (i allready had some)
its finished with a flat edge and a rounded edge
just cut it to suit with the rounded edge pointing out. gives a better finish.
then just wrapped it with 3M carbon wrap.
with it being 90mm wide you can have it comming out as much as you want.
It actually looks far better in real life, just had a friend up at the house there who spent thousands on a body kit and could not believe the finish of this, He still does not believe me, thinks i bought it lol.
if i can find anyone to wrap it in real carbon fibre it would be 100% perfect.
Cheers.
 
5 self tapping 12mm screws into the bottom of the side skits and a fine beed of silcone the whole length.
 
r1andy said:
Thanks folks, i will be getting the rear difusser wrapped in real carbon fibre and a 3D front splitter so these will tie the front and the rear of the car just nice (i hope) :)
Click to expand...
Carbon fibre rear diffuser would be on my wish list :thumbsup:
 
i have found a few places here that work with carbon fibre , so i meeting them tomorrow to see about getting the skirts and rear diffuser carbon wrapped
i might add a small skirt to the bottom of the diffuser before i get it wrapped. Makes it a bit different.
will keep you all posted how it goes.
 
You must log in or register to reply here.
Back
Top Bottom