New Conv Top Issue....No power after electronic lock engage/disengage

0

03Z4e852.5

Member
I'm about to find a cliff and roll it over.....Just kidding. My Z4-E85 was going along after i replaced the top motor them all of the sudden, no power to the motor after the electronic locks disengage or engage.
Not the fuses.... checked all. What in the heck?
 
Where are you?
We could spend ages going back and forth but it’s easiest to find whoever is nearest to work through it with you.
 
03Z4e852.5 said:
Yes. There is no power to the motr in the trunk :cry:
Click to expand...
OK, so potentiually either the control module, or more likely a break in the loom along the left side of the roof. If you can open it manually a little way you can see the loom in the back left corner, above the window. It is covered in protective braid. You need to open it up and check for breaks in the wires just near the top rear corner of the window.
You can get more slack in the cable if you remove the fasteners from the front plastic cover and lower that down to see the loom more clearly.
 
You must log in or register to reply here.
Back
Top Bottom