E89 rear fog light install

[Z4e89uk]

Hi I have a USA spec 35is now in the uk need to get the rear fog light working have UK rear lights and euro light switch with rear fog light my car has 6 wires at the switch but it needs 7 have added the extra wire to the switch using a multimeter but need to know where it goes and how to recode the module I have software to do the programming also want to turn drl off thanks

 

[Smartbear]

Hi I have a USA spec 35is now in the uk need to get the rear fog light working have UK rear lights and euro light switch with rear fog light my car has 6 wires at the switch but it needs 7 have added the extra wire to the switch using a multimeter but need to know where it goes and how to recode the module I have software to do the programming also want to turn drl off thanks

I think I could turn my drl off from the obc stalk & scrolling through the options?
Rob

 

[*AL*]

Curious, why would you want to turn the DRL feature off?

 

[dirklagos]

I also have an E89 from USA now in Portugal and need to do the same. I installed the switch with fog lamp option but need to know else is required????

 

[Bobsealbeach]

Did you ever get a response? I've added the switch and no results. US E89 35i. I have the programming Carly device also if there is a specific item that needs to be changed.

Frustrating. This was easy on my M3 and X1.

 

[clarker63]

If its anything like the time I added heated seats to my E89 I had to update the JBE module to enable them, despite it not obviously being related to the JBE module (I had added the codes to the other modules, but the passenger seat just didn't work - when I loaded the JBE and coded it, with no changes, a click was heard in the JBE and then it worked). I guess if you're running the cable from the switch directly you'd have expected it to work though!

 

[AngryZed]

Hi I have a USA spec 35is now in the uk need to get the rear fog light working have UK rear lights and euro light switch with rear fog light my car has 6 wires at the switch but it needs 7 have added the extra wire to the switch using a multimeter but need to know where it goes and how to recode the module I have software to do the programming also want to turn drl off thanks

I did this for an E85 for the same reasons as you, I believe at the time when I did this mod, E86 was the same procedure (Not positive on E89). Few ways you can go about, I coded mine to enable it and no extra wires were needed. Replace your LSZ or facelift it (much easier) and code away. I'm assuming you already have it worked out, so I'm not adding more.