Drivers window switch replacement

[firefoxchris]

Morning all!

The driver's window switch on my Coupe 3.0si has gone very "flappy" and ready to break off any moment - its had a lot of use over the years. Can I replace just the switch or is it the whole door module? No folding mirrors, photo below.

Is it an easy process to pull the old one out or do I have to take the door off and detatch airbag wiring etc?



Any part numbers, help etc would be appreciated

Cheers!

 

[enuff_zed]

Chris it's really easy.
Trim tool under the front edge of the trim and lift it. Then it should lift out as one unit, but there is a small projecting part at the rear so move it forward a little bit as you lift.
Then just two plugs to undo.
I've got a replacement one here as it happens.
I'll send you a Whatsapp.

 

[firefoxchris]

Awesome, Z4-forum wins again! Thanks @enuff_zed!!

 

[tug]

Take it to bits and give it a good clean. Then when satisfied plug back in, if it works as should, well done, if not take Martin up on his offer. Mine packed up a couple of years back so did this and has worked perfectly ever since.

Cheers, tug

 

[paul__mck]

I have a spare one I bought to replace mine but was able to fix mine so never needed it. If it any use lemme know.

Just pops out. 2 mins would swap em over.

 

[paul__mck]

Ah I see zed has you covered