Butterfingers!

[Chris_D]

That’s annoying

Not sure if it would happen to automotive glass but I’d be a little bit worried about shelling - where now an edge is damaged it can shatter the whole lot without warning.

Seen it happen on shower screens a couple of times where it must have had a tiny imperfection on an edge. As I said this may not be the case here

I think I’d be saving for a new piece of glass

Nah it won't shatter. It's not the same kind of glass you get in a windscreen...or showerdoor.
It won't spider either as its not a crack. Carglass and another place confirmed that.
Just looks a bit horrid.
Going to ignore it til the weekend when i'll try to address it...

 

[john-e89]

Well, not exactly dropped but the person helping me caused me to almost lose my grip on my top corner while i was opening a door. Not blaming them ofc. Just regret not planning ahead properly.

Trying to undo Lou’s boobie hammock while she both hands on your hardon eh Chris....TOP.....I meant hardtop..... :roll:

 

[Chris_D]

Well, not exactly dropped but the person helping me caused me to almost lose my grip on my top corner while i was opening a door. Not blaming them ofc. Just regret not planning ahead properly.

Trying to undo Lou’s boobie hammock while she both hands on your hardon eh Chris....TOP.....I meant hardtop..... :roll:

oh god john please...less of your adolescent fantasizing if u dont mind. u been cranking up that oxygen bottle again? :lol:
and er maybe get her name spelled right, otherwise it may be misconstrued that i'm batting for the same team. It's Lau, not Lou! :roll:

 

[john-e89]

!!!!

 

[ronk]

I would suggest that the resin fill will only stabilise the damage unless vaccum applied.

The lid is only on for a few months and you don’t look at it - try and ignor it.

 

[firebobby]

!!!!

Where did you find that John...snort

 

[john-e89]

:lol:

 

[kis]

Well, not exactly dropped but the person helping me caused me to almost lose my grip on my top corner while i was opening a door. Not blaming them ofc. Just regret not planning ahead properly. This from a project manager too. Fail. :x

Hoping some carefully applied resin/laquer might conceal it a bit.
Couldnt find the chipped bit either. Coulda glued it back on perhaps.
Ho hum.

Feel for you bud! Hopefully you can tidy it up somehow! Best of luck