Recent content by Z-4Noob

I can get my hand to it but the motor is connected by what I perceived as three screws, which I assume can only be torx screws, and there is a bar that gets in the way of the access to the motor from the front. I may go ahead and try to do that though. I’ll have to do that tomorrow after work.

I am in america with the left hand drive version. But yes if it was a right hand it would be under the driver haha.

Hello, I’m new to this forum but I have read a few of these posts and gotten some good information. So here goes with my problem. I have a Yaw sensor that is throwing an electrical fault. I have a replacement for, it however, I understand that the easiest way to replace that part is to remove...