Recent content by PPCZ4

Bumping this in case anyone is able to suggest a possible fix?

So after a lot of hassle I have managed to get INPA running on my mac. I'm not convinced it's fully functional as my steps look different from that link with no F8 'adaptation'. When I open F6 'activate' with the ignition on but engine off I can alter VVT settings, however I get an error message...

Yep, I have also swapped the VANOS solenoids round and the fault still reads the same, apparently relating to the exhaust solenoid. I haven't had the valvetronic calibrated since I replaced the motor, I had seen mixed info with some saying it relearns automatically with the ignition on for 30s...

I have replaced the sensor this evening, feels like the car has a bit more oomph but the codes are still showing in the OBD reader, 2A67 and P1050 "Camshaft position actuator - exhaust, circuit open." is pending this time after a longer test drive than before but clearly the issue isn't resolved...

Oh dear, thanks guys. I was hoping my codes didn't relate to that and to get away without needed a new sensor as it's quite an expensive part. As cleaning it out didn't help, I'll give replacing that a go and hope it solves it.

Hi all, Been trawling these forums for fixes for my 96000 mile E85 2.0i which has proved very helpful over the years, thanks! My latest issue has me running out of ideas though. I have an engine warning light, slight rough idle & power loss, and fault codes 2A67 - 'valvetronic fault' and...