Recent content by Meds

@Pondy Trust fund comment a little harsh ?

Watched, sadly it did feel like the video was created for the tire sponsorship and somehow finding a story to make it fit. (n) I like JayEmm, he talks normal, not inflated or trying to be controversial or over expressionate, I met him last year, nice guy, obviously had good success and making...

Hi guys.. Does anyone have a pair of 10mm 5x120 spacers for the E85 or E86 Coupe.? I can get some new but if someone has a pair unused knocking about, I'd rather re-use than buy new. Bolts not required. Thanks.

2 tickets booked.. Yes! 😁

After a few more miles in the car, learning the intake. I opened up the sound generator by removing the foam and leaving the 'S bend' pipe in the engine bay. I did this previously with the stock and BDS system and hated it, it was far too boomy for me, not a pleasant noise at all.. But on the...

After a few more miles in the car, learning the intake. I opened up the sound generator by removing the foam and leaving the 'S bend' pipe in the engine bay. I did this previously with the stock and BDS system and hated it, it was far too boomy for me, not a pleasant noise at all.. But on the...

Those louvered breather vents, in the boot behind the rear bumper. When slowly reversing up my drive, blipping the throttle at low revs or just general low speed maneuvering I can hear the exhuast side vent flapping about. Like a piece of paper flapping. I noticed this whilst I had some...

Would it be feasible to swap back the high cost parts and sell them separately?

If someone produces good fitting plastic (not fibreglass) rear coupe panels for a sensible price, they'll make a killing!

That's a fine coop you have there. 👍

Rear brakes are finally on..! And they look fantastic, complimenting the fronts perfectly. My OCD is now satisfied. The only note in addition to the post above was a 1.5mm washer required to center the caliper over the rotor, everything else was perfect. The parking brake has been adjusted to...

One guy I've been speaking with from Germany said he's lost a little torque but he's on the sport trumpets and spends most of his time up in the rev range, so it's bothering him too much, and I suspect he will be getting a map sorted for it, too. I'm probbaly keeping the BDS intake elbow so I...

Love it...

Right, here's my mini review after a short drive. Prior: BDS/ITG filter (cylinder removed) and BDS intake elbow, sound generator disconnected with the foam still installed. Product spec: BMW N52B30 Full Carbon CentroPlenum Road length trumpets, fixed airbox. Z4 MAF pipe. Carbon Twill weave...