Not joined yet? Register for free and enjoy features such as alerts, private messaging and viewing latest posts and topics.
Parking Brake Stuck On
- gemeit
- Member
- Posts: 98
- Joined: Sat Feb 11, 2017 9:04 am
- Location: Edinburgh
Parking Brake Stuck On
Hi All looking for some advice my parking brake is stuck on car wont move get the following error coded foxwell NT510 elite
6019: Parking brake control unit internal
6045 : Parking Brake temperature sensor servomotor left
6046 : Parking Brake temperature sensor servomotor Right
6570 : interface dsc
6573 : interface dsc
My thoughts are both brake actuators are faulty or need a new EMF module (does anyone know where it is located) any help / advice would be much appreciated
Thanks
6019: Parking brake control unit internal
6045 : Parking Brake temperature sensor servomotor left
6046 : Parking Brake temperature sensor servomotor Right
6570 : interface dsc
6573 : interface dsc
My thoughts are both brake actuators are faulty or need a new EMF module (does anyone know where it is located) any help / advice would be much appreciated
Thanks
-
OnlineB21
- Lifer
- Posts: 5463
- Joined: Tue Oct 05, 2021 7:15 pm
- Location: In my Banana Yellow Space Shuttle...somewhere over Southern Caledonia
Parking Brake Stuck On
It’s usually the parking brake ECU that’s bricked itself…early ones did..especially with flat / run down batteries..
A good Indy can reflash it
A good Indy can reflash it
We choose to go to on with this endeavour at this time and do the other things, not because they are easy, but because they are hard…
A very modified Atacama Yellow 35is
A very modified Atacama Yellow 35is
- gemeit
- Member
- Posts: 98
- Joined: Sat Feb 11, 2017 9:04 am
- Location: Edinburgh
-
OnlineB21
- Lifer
- Posts: 5463
- Joined: Tue Oct 05, 2021 7:15 pm
- Location: In my Banana Yellow Space Shuttle...somewhere over Southern Caledonia
Parking Brake Stuck On
Well it’s highly unlikely your suddenly going to get parallel faults on both channels..
So if it’s been successfully flashed (I’d expect an error when writing) then it looks like the EMF module has gone south…why did you flash it ?
So if it’s been successfully flashed (I’d expect an error when writing) then it looks like the EMF module has gone south…why did you flash it ?
We choose to go to on with this endeavour at this time and do the other things, not because they are easy, but because they are hard…
A very modified Atacama Yellow 35is
A very modified Atacama Yellow 35is
- gemeit
- Member
- Posts: 98
- Joined: Sat Feb 11, 2017 9:04 am
- Location: Edinburgh
Parking Brake Stuck On
Thank you for your reply.
I flashed it because I thought it was the weak battery issue that many have had. Flash seemed to go ok no errors fault lights all reset whilst updating but when finished warnings came back. Like you I am not sure of both channels going down at same time but did experience slight burning smell couple of days before it stuck on.
-
OnlineB21
- Lifer
- Posts: 5463
- Joined: Tue Oct 05, 2021 7:15 pm
- Location: In my Banana Yellow Space Shuttle...somewhere over Southern Caledonia
Parking Brake Stuck On
Well I guess you can take the units off the rear discs and check…there’s not a lot to them in there as I discovered when I inadvertently motored he pistons all the way out..I got various errors but in the end got them cleared..
We choose to go to on with this endeavour at this time and do the other things, not because they are easy, but because they are hard…
A very modified Atacama Yellow 35is
A very modified Atacama Yellow 35is
- gemeit
- Member
- Posts: 98
- Joined: Sat Feb 11, 2017 9:04 am
- Location: Edinburgh
Parking Brake Stuck On
Thanks that was my next move to inspect them both thanks for the tip re pistons
- gemeit
- Member
- Posts: 98
- Joined: Sat Feb 11, 2017 9:04 am
- Location: Edinburgh
Parking Brake Stuck On
Update
Both brake actuators are fine looks like a fault in the EMF module not releasing pistons.
Does anyone know location of EMF module and if replacement needs coding
Both brake actuators are fine looks like a fault in the EMF module not releasing pistons.
Does anyone know location of EMF module and if replacement needs coding
-
OnlineB21
- Lifer
- Posts: 5463
- Joined: Tue Oct 05, 2021 7:15 pm
- Location: In my Banana Yellow Space Shuttle...somewhere over Southern Caledonia
Parking Brake Stuck On
Here you go
- Attachments
-
- IMG_1907.png (167.42 KiB) Viewed 315 times
We choose to go to on with this endeavour at this time and do the other things, not because they are easy, but because they are hard…
A very modified Atacama Yellow 35is
A very modified Atacama Yellow 35is
- gemeit
- Member
- Posts: 98
- Joined: Sat Feb 11, 2017 9:04 am
- Location: Edinburgh
-
OnlineB21
- Lifer
- Posts: 5463
- Joined: Tue Oct 05, 2021 7:15 pm
- Location: In my Banana Yellow Space Shuttle...somewhere over Southern Caledonia
Parking Brake Stuck On
TIS says it needs to be encoded / programmed…whether something like Protool would allow a re-install of code on such a module I don’t know..
We choose to go to on with this endeavour at this time and do the other things, not because they are easy, but because they are hard…
A very modified Atacama Yellow 35is
A very modified Atacama Yellow 35is
- gemeit
- Member
- Posts: 98
- Joined: Sat Feb 11, 2017 9:04 am
- Location: Edinburgh