Z4 Won't start :tumbleweed:

[logibearsav]

Hey guys new member here just purchased a 2006 Z4 a few days ago yesterday I took to the car for a wash and shortly after leaving a check engine light popped up, a mile before I got to my destination. after parking and going into the store and when coming out My BMW would just turn over and would not start these are my following codes I was able to pull from my scanner any help would be appreciation Thanks Logan

2DE0 NO MESSAGE EKP DME RECEIVER EKP/SBSR TRANSMITTER

5DF4 DSC BATTERY VOLTAGE TOO LOW OPEN CIRCUIT


5E1F DSC CONTROL UNIT INCORRECT VEHICHLE IDENTIFICATION NUMBER CALIBRATION REQUIRED

5E16 DSC NO MESSAGE IKE 610, 613, 615


87 KOMBI K BUS

BE KOMBI DATA-FILING DIFFERENCE TO CENTERAL LIGHT MODULE


6128 EPS VEHICLE SPEED

611D EPS POWER SUPPLY

612A. EPS MILEAGE/KM READING.

[Scubaregs]

Please do not post the same thread in multiple sub forums.

[clarker63]

especially in the E89 section when its clearly an E85 issue!

[flybobbie]

Does no harm, perhaps a former E85 owner might have the solution.
Only post once though, sure twice was an error.

Making this section look unfriendly.