Bit of a clear out - E85 parts

enuff_zed · Post by **enuff_zed** » Fri Mar 31, 2023 11:44 am

Wet day. Bored. Decided to sort through the stacking boxes that are breeding in my garage.
A few items I have duplicates of, so may as well offer them up on here.
Prices include postage.
Happy to take individual photos, double check part numbers etc.

Fuse box - £15 SOLD
Interior mirror - £20
Heater fan - £15
Bonnet switch with bracket - £10 SOLD
Basic interior light - £8
Interior light with map reading lights - £12
Console lock assembly - £15
Console lock electrical actuator - £15
Door pull cables - £10 the pair
Trim panel below the centre console storage door - £8
Hard top electrical connectors - £10 the pair SOLD
Hard top mounting point blanks - £15 the pair SOLD
Final Stage Resistor (Hedgehog) - £30
Auxiliary Fan A/C sensor - £15
Roof control modules (61356954776 x2, 61356936801 x1) - £35 each

: IMG_1544.JPG (152.36 KiB) Viewed 809 times

Bob123 · Post by **Bob123** » Fri Mar 31, 2023 12:06 pm

Wondering what condition is the 'Bonnet switch with bracket' in?

enuff_zed · Post by **enuff_zed** » Fri Mar 31, 2023 12:27 pm

Bob123 wrote: ↑Fri Mar 31, 2023 12:06 pm Wondering what condition is the 'Bonnet switch with bracket' in?

Here you go. Sorry, hard to get a good shot of the plug, but clean and no corrosion.
No spurious alarms in the time I had the car.

: IMG_4019.jpg (64.67 KiB) Viewed 787 times

: IMG_4020.jpg (61 KiB) Viewed 787 times

: IMG_4021.jpg (47.81 KiB) Viewed 787 times

Bob123 · Post by **Bob123** » Fri Mar 31, 2023 12:41 pm

enuff_zed wrote: ↑Fri Mar 31, 2023 12:27 pm
Bob123 wrote: ↑Fri Mar 31, 2023 12:06 pm Wondering what condition is the 'Bonnet switch with bracket' in?
Here you go. Sorry, hard to get a good shot of the plug, but clean and no corrosion.
No spurious alarms in the time I had the car.
IMG_4019.jpg
IMG_4020.jpg
IMG_4021.jpg

Thanks, that looks okay. I believe that the tops wear on them? I'll PM you.

enuff_zed · Post by **enuff_zed** » Fri Mar 31, 2023 1:12 pm

Bob123 wrote: ↑Fri Mar 31, 2023 12:41 pm
enuff_zed wrote: ↑Fri Mar 31, 2023 12:27 pm
Bob123 wrote: ↑Fri Mar 31, 2023 12:06 pm Wondering what condition is the 'Bonnet switch with bracket' in?
Here you go. Sorry, hard to get a good shot of the plug, but clean and no corrosion.
No spurious alarms in the time I had the car.
IMG_4019.jpg
IMG_4020.jpg
IMG_4021.jpg
Thanks, that looks okay. I believe that the tops wear on them? I'll PM you.

PM replied to. Bonnet switch provisionally sold to Bob123 pending payment. Thank you.

Alemito · Post by **Alemito** » Sun Apr 02, 2023 5:30 pm

Hi, how much are those hardtop mounting point covers please?

enuff_zed · Post by **enuff_zed** » Sun Apr 02, 2023 5:44 pm

Alemito wrote: ↑Sun Apr 02, 2023 5:30 pm Hi, how much are those hardtop mounting point covers please?

Hi, they are in the first post @ £15 the pair but that was assuming postage to the UK.
Happy to check out what they may be to you.
They weigh nothing so if you have anything else coming over to you I could send them to that seller to put in the same package if it helps?

Bob123 · Post by **Bob123** » Sun Apr 02, 2023 6:30 pm

Hi enuff_zed, I've been looking at what I think are the 'Hard top electrical connectors' in your photo. Are they the two wires at the bottom of this file, outlined in blue?

: Z4 stuff inc hardtop elec connectors.png (1.3 MiB) Viewed 641 times

If so, I'm wondering how they attach to the hardtop?
I've taken a photo of each end of the connector on one side of my hardtop, attached below.

: Hardtop wire attached to locating post.JPG (115.05 KiB) Viewed 641 times

: Hardtop wire attached to heating element.JPG (135.17 KiB) Viewed 641 times

Do you have any diagrams or RealOem links that help explain how they attach? I'm wondering if I'm somehow missing some connectors.

Thanks

enuff_zed · Post by **enuff_zed** » Sun Apr 02, 2023 6:36 pm

Bob123, you're not missing anything. These are the parts that sit on the top of the front mounting points, under the rubber covers. So when you fit your hard top it makes a connection with the brass ring to enable HRW etc to work.
With your hard top off you'll see the connectors in each corner just behind the door.

Bob123 · Post by **Bob123** » Sun Apr 02, 2023 9:09 pm

Thanks enuff_zed, I’ll take a look tomorrow.

Bob123 · Post by **Bob123** » Mon Apr 03, 2023 4:54 pm

enuff_zed, do you mean around this part somewhere?

: IMG_2019.JPG (121.4 KiB) Viewed 551 times

enuff_zed · Post by **enuff_zed** » Mon Apr 03, 2023 5:09 pm

Yes that is the part. One each side with wires that go down to a plug behind the trim. Worth making sure they are clean and shiny before fitting the hard top

Bob123 · Post by **Bob123** » Mon Apr 03, 2023 5:29 pm

enuff_zed wrote: ↑Mon Apr 03, 2023 5:09 pm Yes that is the part. One each side with wires that go down to a plug behind the trim. Worth making sure they are clean and shiny before fitting the hard top

Thanks, I'll have to have a dig around, I can't see the wires themselves but thought that they must be buried down there from your description.

enuff_zed · Post by **enuff_zed** » Wed Apr 05, 2023 6:31 pm

Bump
Open to offers but please bear in mind these prices do include UK postage.

Brucky · Post by **Brucky** » Wed Jul 26, 2023 9:36 pm

Hi,
Are the Hard top mounting point blanks still available.
Thanks,
John

Z4-forum.com

Z4-forum.com

FOR SALE Bit of a clear out - E85 parts