Radio not recognising AUX

craigbeal · Post by **craigbeal** » Tue Sep 25, 2018 6:26 am

: 6A8AC907-C88A-42D8-BC3C-8810EB1BB2B5.jpeg (254.94 KiB) Viewed 781 times

: 25960C11-3F68-467E-9B7F-E972DBD3AB48.jpeg (273.54 KiB) Viewed 781 times

craigbeal · Post by **craigbeal** » Tue Sep 25, 2018 8:16 am

Tried that and no joy. Reworked as to the 2nd sudjestion and worked. See below for how to wire... mines a 2006 3.0si

craigbeal · Post by **craigbeal** » Tue Sep 25, 2018 8:17 am

: 1FB16C00-23D6-42DE-9FB1-288B74221BB6.jpeg (314.67 KiB) Viewed 775 times

: 41BA0C88-4410-4BC6-995B-073475A28BA5.jpeg (239.91 KiB) Viewed 775 times

: 12D1DFC3-168D-4D8A-AC5B-D4AEEF96CBAF.jpeg (429.08 KiB) Viewed 775 times

Lexx289 · Post by **Lexx289** » Mon Jul 06, 2020 1:19 pm

Hoping there is still some life in here

Before i go any further, i promise, i have read the whole thread from back to front, upside down, and round about. I have connected the aux cable in the right slot in the back, i have soldered in a 300k ohm resister between L and R, and used capacitors too (2x on each in parallel as i origionally bought + - ones so swapped them out). But i am getting no where. I have run a multimeter across the L R to make sure i am getting resistance, and i am, of 300k ohms.

Basically, i plug it in, get FM / AM and CD but no AUX anywhere, ideas?

2004 BMW 3.0i SE with Business headunit.
Images attached.

Any help would be greatly appreciated.

Rockhopper · Post by **Rockhopper** » Fri Jul 31, 2020 4:45 pm

If it’s any consolation I’m having the same problem.

robertboeke · Post by **robertboeke** » Fri May 20, 2022 2:08 pm

craigbeal wrote: ↑Tue Sep 25, 2018 8:17 am 1FB16C00-23D6-42DE-9FB1-288B74221BB6.jpeg41BA0C88-4410-4BC6-995B-073475A28BA5.jpeg12D1DFC3-168D-4D8A-AC5B-D4AEEF96CBAF.jpeg

Not sure how old this is, but thanks for sharing this worked perfectly for me!

Z4-forum.com

Z4-forum.com