Inpa ncsexpert airbag reset

birdy_z4 · Post by **birdy_z4** » Sat Apr 30, 2022 9:24 am

Hi all

Been reading up resetting my airbag warning light since removing my steering wheel

Read that you could do that in INPA by going down to body and airbag

But my inpa only has e90 , battery lights and connection ok, ncsexpert reads the chassis ok

When I go to body and airbag (or anyother module) I get error messages that the module found differs to what expected

Any advice or somewhere I can get inpa with e89

Can you reset in ncsexpert, presume you can but not sure on module

Cheers

Jakg · Post by **Jakg** » Sat Apr 30, 2022 10:23 pm

Do you want to reset the fault code, or permanently turn off the airbags?

If the former, NCSExpert is the wrong tool for the job - INPA is probably better (or ISTA).

birdy_z4 · Post by **birdy_z4** » Mon May 02, 2022 1:27 pm

Jakg wrote: ↑Sat Apr 30, 2022 10:23 pm Do you want to reset the fault code, or permanently turn off the airbags?

If the former, NCSExpert is the wrong tool for the job - INPA is probably better (or ISTA).

Thanks reinstalled inpa from bimmergeeks and now fully reset

Z4-forum.com

Z4-forum.com