Z4Sparky wrote: ↑Sun Mar 24, 2019 5:19 pm
tintoverano wrote: ↑Sun Mar 24, 2019 11:14 am
a quick update, all works now
I'll update.the guide with my findings and send it to you Dave
Any chance of a quick summary of how you fixed the issue as I am undertaking this soon and possibly before the guide is updated.
Cheers
hi, sure
- I only used Expert mode profile to code all along (see above my request to Dave to send me his profiles)
- since I didn't have FRM I used NFRM to add the Vehicle Order
- after adding VO to CAS and NFRM instead of Process Car I re-coded every ECU listed one by one, somehow it felt that Process Car finished too quickly and also a guy suggested this in a post at another forum
- here exit NCSExper, turn off car, take out key, wait 10+ secs
- and I didn't have to use Tool32 to recalibrate DCS, because I didn't have any fault code at all (I don't know why it was like that, it might be that during my previous coding attempts I ran Tool32, but then it had no effect)
I ended up using Easy BMW Tools from here
https://mega.nz/#F!YE82wDha!MTgUZTlrpxN ... g!5McjmQpK - lots of other good stuff there
I hope this helps, I'll try to update the doc asap, good luck