Just a bit of a thread revival but would the honeycomb mod be worth doing on a 3.0 si that does not have a MAF screen or is the air flow across the sensor acceptable in this case ?
All comments welcome I won`t be offended
Just a bit of a thread revival but would the honeycomb mod be worth doing on a 3.0 si that does not have a MAF screen or is the air flow across the sensor acceptable in this case ?
If the OEM MAF of the 3.0si doesn't have a screen then don't place anything in front of it.
I presumed it would hold itself in place once you had cut the slot as on page 5 but otherwise I would think superglue or silicone sealant would be fine .couchflyer wrote: ↑Mon Apr 26, 2021 2:05 am What do you use to secure the honeycomb to the OEM plastic ring with?
Thanks
If you go back a few posts you'll see that I gave a description of how to do this: