Page 1 of 1

Oil filter housing

Posted: Wed Aug 08, 2018 8:03 pm
by Bodyboarder
Hi all ... now the outside of my M is as good as can be the next place I want to turn my attention to is the engine bay . It’s by no means bad but I’d like to polish bits and bobs up .

So my question

Can I remove the top part of the oil filter housing with out draining the oil ?

Can I reuse the nut and what ftlb should it be done to ?

Thanks :thumbsup:

Oil filter housing

Posted: Wed Aug 08, 2018 8:08 pm
by Darren Slone
Yes you can, It’ll clean up lovely, not done mine properly yet :oops:

Oil filter housing

Posted: Wed Aug 08, 2018 8:14 pm
by Bodyboarder
Ok great ... thanks :thumbsup:

Yep can’t wait to get stuck into it ... I find it very satisfying !

Oil filter housing

Posted: Thu Aug 09, 2018 12:18 am
by Seanoog
Darren Slone wrote: Wed Aug 08, 2018 8:08 pm Yes you can, It’ll clean up lovely, not done mine properly yet :oops:
Nice picture. :)
Brings up a question I have about the oil filter housing. What would usually cause the top part of the housing to be covered in engine oil?
Even before the engine is started, and hot?

Too much oil, causing leak's?
Poorly reinstalled oil filter and housing?
Leaking or perished rubber seals, perhaps after missing servicing?

I ask, due to recently viewing a Z4m, with this leakage as described, also rough idle and rough shut off noises, as was why i walked away from buying. I'd appreciate some insight if yous know more.

Oil filter housing

Posted: Thu Aug 09, 2018 3:21 am
by ph001
Yeh, there is a small o-ring that seals the bolt that runs through the centre. Usually comes as part of the kit when you purchase a new filter.

Oil filter housing

Posted: Thu Aug 09, 2018 1:40 pm
by Beedub
OP im going to remove mine and machine polish it at work this week, ill post pics of the results and give you some tips.

Oil filter housing

Posted: Thu Aug 09, 2018 1:54 pm
by Status
I’ve just changed my oil and filter ,I got it from my local BM dealer so was ripped off for fifteen quid instead of eight quid from yer local car parts shop ,had the o-ring with it but as for polishing it it’s clean enuff