The front and back housings unclip, then you need to carefully remove the pre facelift circuit board from your existing controls and fit it with the facelift housings.IAmOrion wrote: ↑Sat May 05, 2018 12:38 amThat’s interesting - I didn’t know that! So not a straight swap then!?Ducklakeview wrote: ↑Fri May 04, 2018 11:35 pm Remember they aren't a straight swap of fitting to a pre facelift as the circuit boards are different.
Mike
Do the dials separate from the board? (Eg can the front be swapped)
I messed my first lot up when removing the circuit board and had to buy another pre facelift heater control. Fortunately they aren't too expensive.