Picked up some BBS

bamberjim · Post by **bamberjim** » Tue Dec 08, 2020 8:20 pm

Going to need some work to get the to fit .... but love a challenge

RX502/508 2 piece

Scooba_Steve · Post by **Scooba_Steve** » Tue Dec 08, 2020 8:22 pm

Pics of dog turds and personal details... 1 out of 3 ain’t bad I suppose....

bamberjim · Post by **bamberjim** » Tue Dec 08, 2020 8:24 pm

Edited... sorry about that

Scooba_Steve · Post by **Scooba_Steve** » Tue Dec 08, 2020 8:27 pm

bamberjim wrote: ↑Tue Dec 08, 2020 8:24 pm Edited... sorry about that

The dangers of tech! I thought there was a polishing reference in there!

inkey$ · Post by **inkey$** » Tue Dec 08, 2020 8:39 pm

They look like they could be good

bamberjim · Post by **bamberjim** » Tue Dec 08, 2020 8:47 pm

Scooba_Steve wrote: ↑Tue Dec 08, 2020 8:27 pm
bamberjim wrote: ↑Tue Dec 08, 2020 8:24 pm Edited... sorry about that
The dangers of tech! I thought there was a polishing reference in there!

bamberjim · Post by **bamberjim** » Tue Dec 08, 2020 8:52 pm

The rears are 18x10 et25, front 18x8.5 et22 going to see if I can get the 5 mm skimmed off the backs

215/40 and maybe 245/35 should help pull them in with a bit of camber...

Got BC coilovers era in the garage to go on, so camber plates on the front, is there much adjustments on the rear?

bamberjim · Post by **bamberjim** » Tue Dec 08, 2020 8:54 pm

bamberjim wrote: ↑Tue Dec 08, 2020 8:52 pm The rears are 18x10 et25, front 18x8.5 et22 going to see if I can get the 5 mm skimmed off the backs

215/40 and maybe 245/35 should help pull them in with a bit of camber...

Got BC coilovers in the garage to go on, so camber plates on the front, is there much adjustments on the rear?

reecey97 · Post by **reecey97** » Wed Dec 09, 2020 8:52 pm

I was looking at these on Facebook and have the machining capability to turn off the hub face... very tempting

Z4-forum.com

Z4-forum.com