CVM: Drive, cowl panel, safety catch - Help!

angelsambrook · Post by **angelsambrook** » Thu Jun 13, 2019 1:52 am

Has anyone gotten the code "CVM: Drive, cowl panel, current too high when opening safety catch" Not sure what this means??

wonkydonkey · Post by **wonkydonkey** » Sat Jun 15, 2019 7:49 pm

This thread came straight up when I Googled it. I can strongly recommend Google as a primary source of info

viewtopic.php?t=95698

angelsambrook · Post by **angelsambrook** » Sun Jun 16, 2019 3:05 pm

Yes- I saw this thread. However- that is not the same code that I got.

Eresti · Post by **Eresti** » Fri Aug 28, 2020 7:14 pm

Hi,
I’m experiencing the same issue... did you solve it?

Jan's Z · Post by **Jan's Z** » Fri Sep 03, 2021 4:20 pm

Angelsambrook - How did you finally fix the problem? My wife's beloved Z is having the same problem. The roof latches close and then reverse without latching and the lift motor doesn't engage. I replaced it and moved it to the trunk and repaired kinked wires in the roof loom. At a loss how to proceed. Any ideas? Thanks.

0x23220040 40 Drive,cowl panel,current too high when opening safety catch
0x23220041 41 Drive,cowl panel,current too high when closing safety catch

Argyll Andy · Post by **Argyll Andy** » Fri Sep 03, 2021 4:27 pm

Jan's Z wrote: ↑Fri Sep 03, 2021 4:20 pm Angelsambrook - How did you finally fix the problem? My wife's beloved Z is having the same problem. The roof latches close and then reverse without latching and the lift motor doesn't engage. I replaced it and moved it to the trunk and repaired kinked wires in the roof loom. At a loss how to proceed. Any ideas? Thanks.

Jan, that member hasn’t been active for over two years so you’re not likely to get a response but hopefully someone else will pop along and maybe able to help

Oh, and hello and welcome

Jan's Z · Post by **Jan's Z** » Fri Sep 03, 2021 9:38 pm

Thanks, Andy, I hope so. As these Z's age, I guess the number of active folks dwindles, but we never run out of things to repair!

JulesW · Post by **JulesW** » Sat Jul 01, 2023 8:11 pm

I have the same code and symptoms. Did anyone discover the resolution to this problem?

Z4-forum.com

Z4-forum.com