Z4-forum.com

Hi can anyone tell me how to split the side indicators as i have replaced all the other badges for carbon. and just need to do these now.
Cheers Moz

Sent from my GT-I9300 using Tapatalk 2

Remove the indicator (gentle pressure in, and twist), then use a plastic credit card, or thin nylon string under the badge edge. Don't use a knife as it damages the badge. Also, you may want to mark the top of the indicator before removing the badge, otherwise you will put them back wonky

Thanks i'll give it a go
Moz

Sent from my GT-I9300 using Tapatalk 2

Had to use knife afterall.carefully.
There stuck on so inserted the thin knife and carefully cut thro the glue.
Pic for anyone else doing it

Thanks moz

Sent from my GT-I9300 using Tapatalk 2

Anyone know what size these badges are? Where can you get real OEM ones from?

tomscott wrote:Anyone know what size these badges are? Where can you get real OEM ones from?

Part number is shown on the picture above, so any dealer.

out of interest what do people use to stick these back on?

Double sided tape - Halfords number plate tape would work well (not the really thick stuff though!). You can pick up double sided tape from eBay for a few quid...

Yeh I have some double sided tape. Not sure that will hold well enough!

I also happen to have some licence plate fixers but they are about 3mm thick. Might use some hot glue/silicone/hardasnails!

Remember that you may want to replace the badges at some stage the tape has held well for me for some time now, so should be fine.

I ended up using some power grip tape from toolstation. Weatherproof and very strong (but should still be able to remove when needed)

http://www.toolstation.com/shop/Adhesiv ... 420/p63962

Highly recommend this! Used it for my french fries too