My z4 3.0 project thread (lots of pics)
Posted: Thu Jul 26, 2012 6:51 pm
Hello everyone
New to the forum, but I've already started doing a few bits to my z4
Here is my mod list:
So far:
Foam Removed From Soundgenerator
Oil, Air and Pollen filters replaced
Diff, Gear box and Engine Oil changed
De-baged
De-french fried
Extiror Trim Restored with G'Technique
Interior Trim wrapped with 3m Vinyl
Replace Aux And Air Con Belts + Tensioner
Dice Installed
TR30 Speed Camera Detector Installed
Re-mapped to 239 BHP and 229 ib/ft
Mods planned
Painted caliipers
Retro Fit MFSW
Steering Wheel Re-Trimmed
Retro Fit Cruise Control (ordered part)
Smoked Head And Tail Lights (lamin-x Ordered)
Short Shifter (ordered) + M Gear Knob
Detail
Here it is as I bought it:
And here is what I've done so far:
Debaged
to:
De-french Fried
Before:
After:
I restored all the exterior trim with C'techniq C4 - I used this on my 3 series and its permanent, wont wash off or fade
They look good as new now
Before:
After:
I also tidy'd up the intior trim,
I wrapped the door handles in 3m matt grey vinyl from ebay as they were chipped and scratched, and i have sprayed the ash tray as i couldnt wrap it as the shap was too hard
And the gear surrond not only had a hole drilled in it, all the clips had been broken so i have ordered a new one
Before:
After:
More to come
Sent from my GT-I9300 using Tapatalk 2
New to the forum, but I've already started doing a few bits to my z4
Here is my mod list:
So far:
Foam Removed From Soundgenerator
Oil, Air and Pollen filters replaced
Diff, Gear box and Engine Oil changed
De-baged
De-french fried
Extiror Trim Restored with G'Technique
Interior Trim wrapped with 3m Vinyl
Replace Aux And Air Con Belts + Tensioner
Dice Installed
TR30 Speed Camera Detector Installed
Re-mapped to 239 BHP and 229 ib/ft
Mods planned
Painted caliipers
Retro Fit MFSW
Steering Wheel Re-Trimmed
Retro Fit Cruise Control (ordered part)
Smoked Head And Tail Lights (lamin-x Ordered)
Short Shifter (ordered) + M Gear Knob
Detail
Here it is as I bought it:
And here is what I've done so far:
Debaged
to:
De-french Fried
Before:
After:
I restored all the exterior trim with C'techniq C4 - I used this on my 3 series and its permanent, wont wash off or fade
They look good as new now
Before:
After:
I also tidy'd up the intior trim,
I wrapped the door handles in 3m matt grey vinyl from ebay as they were chipped and scratched, and i have sprayed the ash tray as i couldnt wrap it as the shap was too hard
And the gear surrond not only had a hole drilled in it, all the clips had been broken so i have ordered a new one
Before:
After:
More to come
Sent from my GT-I9300 using Tapatalk 2