Hello,
First time poster here. I recently got a 2008 Z4 3.0 and have been loving it. I bought the car with a few lights on but they weren't too serious. The three lights that were/are on are the tire pressure warning, a light bulb warning light, and a yellow Brake light. I was told by my mechanic who is a BMW specialist that it was the steering angle sensor and that he didn't have the machine to clear it. He had a normal machine that would clear the codes but they would come right back after. I've been searching around and have been reading that you either go to the dealership or you find someone who has the genuine BMW code machine. I'm a little apprehensive to go and pay $100-$200 (probably) just for them to plug it in and clear it. Any and all help is appreciated. Thank you!
Not joined yet? Register for free and enjoy features such as alerts, private messaging and viewing latest posts and topics.
Steering Angle Sensor?
-
- Member
- Posts: 644
- Joined: Sun Aug 05, 2018 12:14 pm
- Location: Hershey, PA USA
Steering Angle Sensor?
I have the same lights. I cleared them with INPA software. It will also tell you the error codes. It might only be one of your wheel speed sensors being dirty or intermittent.
Are you sure your specialist is really an expert if he doesn't have software? The software is free.
Are you sure your specialist is really an expert if he doesn't have software? The software is free.
- Bobbthemonkey
- Newbie
- Posts: 17
- Joined: Mon Mar 11, 2019 10:56 pm
Steering Angle Sensor?
He's used to more of the older generations of Bimmers, before a lot of the gadgets were put in. They suggested I just go to a dealer although I reckon I'll ask if they've thought of downloading the new software. I'm not even sure what kind of reader they were using. How much do one of those run in your own experience if I were to just buy one on my own and clear it myself? Also what brand, model, etc. is yours?
Last edited by Bobbthemonkey on Tue Mar 12, 2019 12:36 am, edited 1 time in total.
-
- Member
- Posts: 698
- Joined: Fri Jan 09, 2015 10:43 pm
Steering Angle Sensor?
mine happened after battery was disconnected, local garefe use hand held cgecker and calibrated it, lights never came back
-
- Member
- Posts: 644
- Joined: Sun Aug 05, 2018 12:14 pm
- Location: Hershey, PA USA
Steering Angle Sensor?
Diagnostic cable is about $25 and software download is free. It can be tricky to install. Must be installed in windows xp compatability mode.
- Bobbthemonkey
- Newbie
- Posts: 17
- Joined: Mon Mar 11, 2019 10:56 pm
Steering Angle Sensor?
I just head about the Carly device. Do you think that could clear the fault codes?
- ph001
- Lifer
- Posts: 3870
- Joined: Mon Oct 31, 2016 5:53 pm
- Location: N. Yorkshire.
Steering Angle Sensor?
You probably need to recalibrate the steering angle sensor which can be done in INPA. Carly will reset it but thats all.