MFSW refurb

Simon 3.2M · Post by **Simon 3.2M** » Wed May 16, 2018 7:02 pm

It's time to refurb my steering wheel but I'm struggling to find a Star drive small enough to remove these from the controls. Anyone know the size?

Post by **srhutch** » Wed May 16, 2018 8:22 pm

Shouldn’t be that hard, I have a set of torx drivers and screwdriver bits from screwfix, both have bit that fit.

Simon 3.2M · Post by **Simon 3.2M** » Wed May 16, 2018 9:41 pm

Simon 3.2M · Post by **Simon 3.2M** » Thu May 17, 2018 6:01 pm

It it possible to get the larger paddle switch out? I've refurbed the other parts but not sure how I remove this without damaging it.

: IMG_0697.JPG (257.24 KiB) Viewed 690 times

Post by **srhutch** » Thu May 17, 2018 7:03 pm

I left in place and masked up ensuring tape went right down the sides.

Simon 3.2M · Post by **Simon 3.2M** » Thu May 17, 2018 8:34 pm

Did you do them matt or satin black?

firebobby · Post by **firebobby** » Fri May 18, 2018 10:11 am

Did my ones in satin black

: IMG_0849.JPG (178.06 KiB) Viewed 615 times

AveZ4coop · Post by **AveZ4coop** » Sat May 19, 2018 4:53 pm

I masked mine rather than strip down. All went OK. I removed all the rubberised gunk and have done all my spokes and control surrounds satin silver to match the dash and interior trim. Looks quite nice.

Simon 3.2M · Post by **Simon 3.2M** » Sat May 19, 2018 5:49 pm

Good man!

Z4-forum.com

Z4-forum.com

MFSW refurb

MFSW refurb

MFSW refurb

MFSW refurb

MFSW refurb

MFSW refurb

MFSW refurb

MFSW refurb

MFSW refurb

MFSW refurb