exhaust pipe diameter 3.0si

bobo075 · Post by **bobo075** » Fri Feb 09, 2018 10:56 am

Hello,
Does anybody knows the diameter of the pipe on the 3.0si... not talkink about the tips but the pipes to remove the rear muffler....
I found somewhere 48mm but not sure...

Regards

Ducklakeview · Post by **Ducklakeview** » Fri Feb 09, 2018 10:59 am

It's just under 50mm outside dia.

Mike

bobo075 · Post by **bobo075** » Fri Feb 09, 2018 11:05 am

Thank's Mike

James93 · Post by **James93** » Thu Nov 21, 2019 5:26 pm

Anyone know the diameter of the 3.0 e85 exhaust entering the back box? I want to replace the back box with 2 bullet mufflers if I can figure out a decent design/products to use. Really confused

Smartbear · Post by **Smartbear** » Thu Nov 21, 2019 5:59 pm

James93 wrote: ↑Thu Nov 21, 2019 5:26 pm Anyone know the diameter of the 3.0 e85 exhaust entering the back box? I want to replace the back box with 2 bullet mufflers if I can figure out a decent design/products to use. Really confused

I believe the 3.0i and the 3.0si have the same size pipes leading to the back box

Rob

G600 · Post by **G600** » Thu Nov 21, 2019 7:33 pm

For the 3.0i you'll want these (48mm slotted stainless with clamps), I used 50mm at first but they were a bad fit https://rover.ebay.com/rover/0/0/0?mpre ... 1924888377

James93 · Post by **James93** » Thu Nov 21, 2019 10:05 pm

Thanks rob and g600, did you get the straight or stepped connectors? Will have to see if I can fit 1 of those on either end of the muffler to connect it to pipes and exhaust tips

Z4-forum.com

Z4-forum.com