Z4-forum.com

Guys I am looking for something to help keep my wheels easy to clean. At the moment I have only ever use Autoglym alloy where protector , which is a spray , and probably mainly silicone, but there must be something better ?

Many thanks

Collinite 845 insulator wax or Finishcare 1000P hi-temp sealant.

I have used SwissVax Autobahn on many car wheels and I regard it as the best wheel wax. It typically lasts 4 months on a daily driver. I always remove the wheels to clean and polish before applying the wax. High-end sealants might be better, but cost a lot more.

Z4C_er wrote: ↑Thu May 10, 2018 8:48 am Collinite 845 insulator wax or Finishcare 1000P hi-temp sealant.

Another vote for FK1000P its cheap easy to apply and works, ask the same question on Detailing World and you'll get loads of votes for FK1000p

Thanks guys will take a look.

Gtecnik c5 without a doubt.

Gtechniq C5 is amazing sealed mine over 7 months ago and still beading great

I agree Gtechniq C5 is very good but it's expensive and not as easy to apply.
But if the OP dosent mind the expense, it's certainly worth considering for the longevity

I used the gtechniq C5 on my alloys about 2 years ago. They're still as easy as ever to clean. The barrels especially are very easy. Usually, the brake dust and dirt gets stuck to the insides, but no such worries on my alloys.

Just bought the gtechnic c5 from slims detailer got the pack of three wheels tyre clean and wheel clean prior to the c5 twenty five quid getting the wheels refurbished this week then on with the protection
Hope is as good as you lads say
I’ll let you know
Geoff