Changing indicator stalk to a cruise control stalk

[B21]

I got home, swapped the slip ring over, putting the original one back on the car, and now have fully working steering wheel buttons! I did look at the slip ring I HAD put on the car, and it appeared to be missing a white plastic pin/peg, so there was something not right with it.
Happy bunny...now to wait for bimmer geeks to deliver my Bluetooth OBD dongle, so I can use pro tool and get the cruise control coded in ...wish me luck!!

[N4LLY]

.wish me luck!!

Result. Good luck

[Steham]

Dave....

I've enabled the cruise control using bimmergeeks protocol....not sure if I would have $540 or $544 value I should have added.
Ever since I changed my stalks over, sorted slip ring prob over, I've had orange DSC warming light and orange tyre pressure warning light on....any ideas?

Steve

[AnubisZed]

Dave....

I've enabled the cruise control using bimmergeeks protocol....not sure if I would have $540 or $544 value I should have added.
Ever since I changed my stalks over, sorted slip ring prob over, I've had orange DSC warming light and orange tyre pressure warning light on....any ideas?

Steve

544 is what you should be adding to the VO.
The warning lights are because you need to reset the Steering Angle Sensor, as it's now out of calibration.

[Steham]

Hi,

Thanks or the swift reply, really appreciate it.
I'm using bimmergeeks protool, and as far as I was aware, I went into steering angle section, and recalibrated it...must have not done it right.
I'll have a other look at it tomorrow

Many thanks

Steve