The steps for full swap are -;
- Jack front of the car
- remove both front wheels
- remove the cover from the undertray(two plastic holders that hold it in place)
- remove the backing from the headlight(metal clip holding it)
- unclip the cable connector
- loosen the torx screws a little(you don't have to but plastic is usually old and might snap so I did loosen them)
- twist the whole housing to the side(torch in there to see which side is open/close)
- pull it out and then you'll have the below:
should look like this after -;
You'll then be able to pull the halogen bulb out -;
inside looks like this, for better understanding -;
once you jam your new LED in -;
reverse order to put it back together and you should have -;
A few notes -;
Bulb type - BA9S
Bulbs used in example - http://www.ebay.co.uk/itm/2x-27-SMD-LED ... 2749.l2649
Bulb error - Is there, you will need to code it out with Carly or any other BMW codding software..
Colour - These look blue but they're simply "pure white"
Hope someone finds this useful!
Buckz