Not sure if this has already been done - couldn't find a decent guide, so hope the following helps;
Part numbers for OEM LED rear number plate lights and connectors;
Connectors; 61138365340 x2
Lights; 63267193294 x2
First of all, take the old units out - they pivot from the left, so take your flat head screw driver (protected with a cloth) to the right side and remove.
Once hanging down by the wire, disconnect the connectors and you'll see how they are different;
You need to look at the back of the original connector for a tab. Lift this up with a small screw driver and pull the sleeve of the connector back up the wire like so;
Next remove the white locking collar which just unclips using your nails;
Then, from the above photo, you can see that the pins at the end of the wires have a slightly raised barb. Push this gently and pull back the wires together (again, gently) and the pins will release from the plastic connector;
Reverse the process with the new connectors and should end up with;
And lights on;
(iPhone makes it look yellow, also thanks to the crap Photobucket quality).
Not joined yet? Register for free and enjoy features such as alerts, private messaging and viewing latest posts and topics.
OEM LED number plate lights
-
- Member
- Posts: 76
- Joined: Sun Jun 14, 2015 12:54 pm
- Location: Worcestershire
OEM LED number plate lights
Great guide, Thank you
Saved a lot of trial and error, I owe you a drink
Saved a lot of trial and error, I owe you a drink
- dj_jormi
- Newbie
- Posts: 43
- Joined: Sat Apr 06, 2019 8:59 am
- Location: Spain